The answer is the same for both: 7 or 8 places, same as MIPS. All three use the same IEEE standard for single precision float. (But be careful: some C compilers allow you to specify how many bits of precision you want for various data types. Also, C implemented on a weird machine might be non-standard).
| Instruction | Operation |
|---|---|
| abs.s fd,fs | $fd = |$fs| |
| add.s fd,fs,ft | $fd = $fs + $ft |
| sub.s fd,fs,ft | $fd = $fs - $ft |
| mul.s fd,fs,ft | $fd = $fs * $ft |
| div.s fd,fs,ft | $fd = $fs / $ft |
| neg.s fd,fs | $fd = -$fs |
Here
are some single precision arithmetic instructions.
Each of these corresponds to one machine instruction.
There is a double precision version of each instruction
that has a
"d" in place of the "s".
So add.s becomes add.d and
corresponds to the machine code that adds
two double precision registers.
The first instruction computes the absolute value
(makes a positive value) of the value in register $fs
If the data in an operand register is illegal or an illegal operation is performed (such as division by zero) an exception is raised. The IEEE 754 standard describes what is done in these situations. This will be discussed in a later chapter, not yet written.
(Thought Question: ) How does the abs.s instruction
alter the 32-bit pattern of the float?