ENTER 40 values. These are HP readings every 100 rpm starting at 2500.
190
200
210
215
220
223
229
238
246
246
253
264
267
269
272
272
274
275
275
275
275
271
268
261
253
246
238
229
223
216
214
211
208
204
201
180
170
160
150
140
STOP entering RPM's after 35th. Below, enter RPM data from a drag run. start at 2500 rpm (or your launch rpm), count "clicks" for the rise in RPM from launch to top of first gear.
base RPM
2500
seconds or clicks in 1st (amount of time in first gear)
18
top of 1st gear rpm
5600
bottom of 2nd grar rpm (this is after the SHIFT, what RPM does the engine DROP TO)
4000
seconds or clicks in 2nd
15
top of 2nd gear rpm (again, highest RPM seen in second)
5300
bottom of 3rd gear rpm (whan it shifts, what does it go DOWN to)
3900
seconds or clicks in 3rd (up until traps). It helps if you let off right at the traps.
50
top of 3rd gear rpm (at traps)
5300
END OF FYLE (spelling mistake intentional, TIM  ;-P

P.S. .. you must enter HP values for ALL entries above, up to 6000 rpm. If you don't know them.. do like I did and estimate.. it wont matter if you don't shift up there anyway.

PPS.. If you want to submit MORE THAN ONE dyno run.. call the files "dyn2.txt, dyn3.txt". the software supports multiple files